| This forum is for all years of the Ford Galaxie and all other Full-size Ford, Lincoln, and Mercury cars. This is a place to share information, skills, pictures, and stories for the purpose of building friendships and furthering the enjoyment and restoration of these cars |
Offline
left over parts from my project for sale.
4 galaxie 500 hub caps.
below the grille trim,
back trim band the one that goes above the trunk but below the back window
drivers side rocker panel trim,
cowl panel.
bench seat and parts,
side mirrors in rough condition
, fender ornaments new aftermarket,
, dog dish moon hub caps..3 with some dings,
power steering remote reservoir,
generator/alternator bracket,,
starter motor for fe block 390
cruise o matic 390 flexplate and center ring.
fog light lens,
courtesy light bezels (fastback)
.fuel and temp gauge lens,
speedometer bezel,
bucket seat plastic side trim.
Pair of tail light lens w/out back up light.
Original used scuff plates rough condition
.
Last edited by g-man (November 4, 2017 7:32 am)
Offline
email me at glenmead@comcast.net if your are looking for any of these parts
Thread StarterOffline
Nice hubcaps. I am sure they will find a new home sooner than later.
Offline
The galaxie hubcaps are nice ...dent free with some minor wear in the centers as seen in pics. They will polish up nicely. I also have a 63/64 hood avail for local pick up. It is dented and has some surface rust on the underside but is still fixable. I have a 64 radio face plate and some 63 galaxie emblem parts. I have a power steering pressure hose that is new but was installed on my car for a small time mostly while it sat in my garage.
Thread StarterOffline
exhaust manifolds are SOLD
Thread StarterOffline
I hunch your not restoring your Galaxie to original specs.
Offline
yes ..non original. deleted the rocker trim, trim below the grill, trim on the c post and back band. removed the bench seat for 62/63 buckets. BTW bucket seats do not conform to a bench seat floor. The floor is too high. Putting the bucket seats too high and getting your head close to the headliner. I cut my bucket seat brackets to lower but still somewhat high. Also removed the cruise o matic for a c6.
Thread StarterOffline
Sorry for being rude. I'm learning that only a tiny percentage of the participants of this forum restore their
Ford Galaxies to original specs. Finding tech support is not easy.
Good luck on your project.
Offline
Hood has been hauled away for scrap metal. Rest is still available. email me for inquiries glenmead@comcast.net
Thread Starter
1 of 1