Galaxie Forum Full-size Ford, Lincoln, and Mercury DazeCars www.galaxieforum.com


This forum is for all years of the Ford Galaxie and all other Full-size Ford, Lincoln, and Mercury cars. This is a place to share information, skills, pictures, and stories for the purpose of building friendships and furthering the enjoyment and restoration of these cars

You are not logged in. Would you like to login or register?



December 9, 2019 7:15 am  #1


1961 Front Hub Lug Stud Removal

Does anyone have any experience removing the front lug studs from a 1961 Ford.  I pounded them out with a hammer but they were really difficult to remove this way.  Should they be pressed in and out?

 

December 13, 2019 10:17 pm  #2


Re: 1961 Front Hub Lug Stud Removal

Mine is a 1967 gal with drum brakes. I stripped everything off and then removed the front hub. Using a press, I pressed them out and then pressed them in. They came out hard and went back in somewhat easy. With the hub only, you have clearance for the press ram. I am assuming you're car has drum brakes also and a similar design. I believe that I used socket to put them back in for clearance on the thread end and to give something square to
push against.

 

December 15, 2019 6:58 am  #3


Re: 1961 Front Hub Lug Stud Removal

Thanks for the reply.  Yes, mine has drum brakes and I believe it is the same design as your 67 Galaxie.  Driving the lug studs out with a hammer was a real chore.  It's really easy to damage the hub with one errant hammer strike.  I was thinking about getting a Harbor Freight press to press the lug studs back in.  They have a 12 ton press that is pretty cheap.  Do you think a 12 ton press is big enough to press them in and out?

     Thread Starter
 

December 16, 2019 8:42 pm  #4


Re: 1961 Front Hub Lug Stud Removal

Yes, my press is a 6 ton Harbor Freight unit.

 

Board footera

 

Powered by Boardhost. Create a Free Forum