| This forum is for all years of the Ford Galaxie and all other Full-size Ford, Lincoln, and Mercury cars. This is a place to share information, skills, pictures, and stories for the purpose of building friendships and furthering the enjoyment and restoration of these cars |
Offline
I finally got time to work on the Galaxie again. Got the rear seat, home made side panels, carpet and dash in. Putting parts on the engine. Hopefulluy dropingit in a week from this Saturday.
Offline
wicked61 - I did measure and got a 5" offset rim, put them on and did a little trim job on inner fenders.
eric21477 - You need to cut the mounting brackets out on the car you get the interior from. I just welded the brackets right over the existing frame of the car. Also I welded bolts to the floor for the front seats. The wiring was not too hard to figure out. I just did not wire for the automatic seat adjustment reset.
Thread StarterOffline
That engine sure is purdy, just can't bring myself to call it pretty. The interior is awesome too. Keep up with the pictures.
Offline
Thanks for the info on the seats. Car is coming along nicely!
Offline
I love those seats!! They look like Ford put them there.
Offline
Engineis in. Waiting on clutch fork to install trani. Almost done!!!!!!!!!!!!!!!!
Thread Starter